Kanguru Mobile Clone 1HD Duplicator - Manual (Page 8)

8
Hardware Setup
1.4 Hardware Setup
1. Place the Kanguru Mobile Clone where there is proper ventilation. Avoid using the Kanguru
Mobile Clone in environments with high temperatures or extreme humidity.
2. Make sure that sufficient power is supplied to the KanguruClone. Incorrect power will cause
faulty operation.
3. You are now ready to begin using your Kanguru Mobile Clone. To begin, turn on the duplicator
by connecting the power adapter from an electrical outlet to the unit’s power port.
Things to remember
• Make sure that sufficient power is supplied to the Kanguru Mobile Clone. Incorrect power may
cause faulty operation.
• The KanguruClone supplies power to drives during a duplication session. There is no need to
connect an external power source to the drives. The unit can supply up to 1.5A at 12V and up to
1A at 5V to each drive.
Note: the drives are not powered until you execute an operation.
• It is OK to connect and disconnect Master or Target drives while the Kanguru Mobile Clone is
powered on. However, do NOT connect or disconnect drives while any operation is running or
is in progress.
• The supplied cables are NOT standard cables like the ones found in a PC. Do not attempt to use
these cables in a PC nor to use PC cables with the Kanguru Mobile Clone. Doing so may cause
damage to the unit and/or drives.
• Connect all Master and Target hard drives before you execute an operation.