Kemppi MIG 2530 - Manual (Page 13)

EN
4. MAINTENANCE
4.1 Daily maintenance
NOTE! Be careful of mains voltage when handling electric cables!
Clean the wire channel of the electrode and check the contact tip regularly. Always check the
condition of the mains and welding cable before operation and replace defective cables.
NOTE! Only a competent electrician is allowed to remove or install the mains cable!
4.2 Regular maintenance
KEMPPI -service workshops sign special service contracts with customers for regular
maintenance. All parts are cleaned, checked and if necessary, repaired. Also the operation of
the welding machine is tested.
4.3 Disposal of the machine
Do not dispose of electrical equipment with normal waste!
In observance of European Directive 2002/96/EC on waste electrical and electronic
equipment, and its implementation in accordance with national law, electrical equipment
that has reached the end of its life must be collected separately and taken to an appropriate
environmentally responsible recycling facility.
The owner of the equipment is obliged to deliver a decommissioned unit to a regional
collection centre, per the instructions of local authorities or a Kemppi representative. By
applying this European Directive you will improve the environment and human health.
5. ORDERING NUMBERS
Kempact MIG 2530 621853002
GH 30 Gun holder 6256030
MMT 25 3 m 6252513MMT
MMT 25 4.5 m 6252514MMT
MMT 27 3 m 6252713MMT
MMT 27 4.5 m 6252714MMT
Earth cable 35 mm² 5 m 6184311
Transport unit ST 7 6185290
Transport unit P250 6185268
Lift hook 4298180
Wire spool pole 4289880
5 kg spool adapter 4251270
Gas hose 6 m W000566
11
© Kemppi Oy / 1204