Denon AVR-3310CI - Manual (Page 8)


ENGLISH
Connections
Set
tin
g
s
Pla
ybac
k
Inf
or
mation
Specifications
Get
ting Star
te
d
Una
vailable F
unctions
Af
ter Upgr
ading
Make the Optimal Speaker Settings, and Correct the Room Acoustics (Audyssey™ Auto Setup)
s Audyssey Auto Setup Preparations
around items indicate the default setting.
Perform the following settings if adjustments, etc., are required for
the speaker environment you’re using.
If you do not need to perform the following settings, or have already
completed them, select “Auto Setup Start” and then press ENTER .
Proceed to “ STEP2 ”.
When you are using surround back speakers with ZONE2/ZONE3,
set to “ZONE2” or “ZONE3”.
You can set in the same way as described in “Amp Assign” on page
8.
•
•
Change the Amplifier Assignment (Amp Assign)
The signal output from the SURR.BACK/AMP ASSIGN speaker
terminal of the AVR-3310CI can be switched to match your speaker
environment (vpage 8 “Amp Assign”).
1
Press ui to select
“Amp Assign”, then
press ENTER .
NOTE
Since “Amp Assign” of AVR-3310CI is set to “ZONE2” by default,
audio is not output from the surround back speakers. When using the
surround back speakers with MAIN ZONE, change the “Amp Assign”
setting to “Normal”.
v page 30 of GThe original versionH Operating Instructions
d Perform Audyssey Auto Setup
Main remote control
operation buttons
:Displaying the menu
Cancel the menu :Moves the cursor
(Up/Down/Left/Right)
:Confirm the setting :Return to previous menu
STEP1 Preparation
Set the channel to be measured (Channel Select)
v page 30 of GThe original versionH Operating Instructions
v page 29 of GThe original versionH Operating Instructions
a Connect the Included Setup
Microphone
2
Press o p to select Amp Assign Mode, then press
RETURN .
Normal
ZONE2
ZONE3
ZONE2/3-MONO
Front A Bi-Amp
Front B Bi-Amp
Front Height
Front Wide
: The surround back channel audio signals are
output.
: The ZONE2 audio signals are output.
: The ZONE3 audio signals are output.
: The ZONE2 / ZONE3 monaural audio signals are
output.
: The bi-amp audio signals are output. Set this for
bi-amp playback of the front A speakers.
: The bi-amp audio signals are output. Set this for
bi-amp playback of the front B speakers.
: The front height channel audio signals are output.
: The front wide channel audio signals are output.
indicates functions added by upgrading.
NOTE
• Loud test sounds may be played during Audyssey MultEQ®
automatic speaker setup. This is part of normal operation. If there
is background noise in room, these test signals will increase in
volume.
• Do not stand between the speakers and setup microphone or allow
obstacles in the path while the measurements are being made. This
will cause inaccurate readings.
• Make the room as quiet as possible. Background noise can disrupt
the room measurements. Close windows, silence cell phones,
televisions, radios, air conditioners, fluorescent lights, home
appliances, light dimmers, or other devices as measurements may
be affected by these sounds.
Cell phones should be placed away from all audio electronics during
the measurement process as Radio Frequency Interference (RFI)
may cause measurement disruptions (even if the cell phone is not in
use).
Operating
MASTER VOLUME during the measurements will cancel
the measurements.
•
Set
tin
g
s