Kleenmaid IC57 - Manual (Page 2)

2
Contents
!
Introduction ................................................................. 2
Safety Instructions ...................................................... 2
Materials Required ...................................................... 2
Tools Required ............................................................ 2
Parts ........................................................................... 3
Procedure ................................................................... 4
Operating Instructions ................................................. 7
Before Calling For Service ........................................... 7
Warranty ..................................................................... 8
Introduction
Recognize this symbol
as a safety precaution
CAUTION !
To avoid personal injury or property damage, observe
all safety instructions.
Read entire manual before installing kit. All necessary
tools and materials must be available prior to installation.
Verify all listed parts are included in kit. If parts are
missing, contact source from whom kit was purchased.
• Mechanical experience is required to install kit.
• Depending on installer’s knowledge and skill,
installation can take from 3 to 6 hours.
• If unable to solve a problem during installation, contact
an authorized Amana technician. Locate a Factory
Service Center or independent authorized Amana
technician by calling 1-800-628-5782 inside U.S.A. and
1-319-622-5511 outside U.S.A. Service is at owner’s
expense.
A qualified engineer must connect ice maker in
accordance with these installation instructions. A qualified
engineer must follow local electrical and plumbing
connection regulations.
Safety Instructions
WARNING !
To avoid electrical shock which can cause severe
personal injury or death, disconnect power to
refrigerator before installing kit. After installing kit,
connect power.
CAUTION !
To avoid property damage, observe the following:
• Confirm water pressure to water valve is at least 138
Kilopascals.
• Start nuts by hand to avoid cross threading. Finish
tightening nuts using an adjustable wrench. Do not
overtighten.
• Check carefully for water leaks prior to returning
refrigerator to normal location and 24 hours after
connection.
Materials Required
Important
• Before connecting ice maker, contact a plumber to
connect copper tubing to household plumbing in
compliance with local codes and ordinances.
• Do not use self-piercing valve. Amana Appliances is
not responsible for property damage due to improper
installation or water connection.
6 mm flexible copper tubing*.
*Length of copper tubing must reach from water supply
connection plus an additional 2 meter for service loop
behind refrigerator. Tubing should be soft instead of rigid
and ends should be free of burrs.
Tools Required
• 9.5 mm ( 3 /
8
") Electric drill (ground fault protected)
• 9.5 mm ( 3 /
8
") Drill bit
• 6.35 mm ( 1 /
4
") Drill bit
• Center punch
• Hammer
• 6.35 mm (
1 /
4
") Hex nut driver
• 12.7 mm (1 /
2
") Open-end wrenches (2)
• Bucket
• Tight fitting gloves
• Putty knife
• Masking tape
• Pliers
• Screwdriver
• Slip joint pliers
• Towel