Kleenmaid IC57 - Manual (Page 7)

7
Operating Instructions Before Calling For Service
Give ice maker 1 overnight period to make ice before
assuming a difficulty exists.
If ice maker is not producing ice
• Confirm ice maker arm is down. Ice bucket and slide
out shelf must be in proper position for ice maker to
produce ice.
• Confirm household water supply is reaching water
valve.
• Confirm ice maker wiring harness is completely
inserted into receptacle.
• Check for kinks in copper or plastic tubing. Remove
kinks or replace tubing.
• Check electrical connections to water valve coil and
connector block on refrigerator cabinet.
• Confirm freezer is operating at proper temperature.
If ice maker is not producing enough ice
• Ice maker produces 7 to 9 harvests of ice in a 24-hour
period under ideal conditions.
• See above section.
If ice maker makes unfamiliar sounds.
• These may be normal. Refer to “Normal Operating
Sounds” section in Owner's Manual.
• Confirm ice bucket is in place and ice maker arm is
down.
A
B
A. Off locked position.
B. On position.
• After freezer section reaches normal temperature, ice
maker fills with water and begins operating. Allow 24-
48 hours after installation before first harvest of ice. Ice
maker produces 7 to 9 harvests of ice in a 24-hour
period under ideal conditions.
• After ice is formed, ice maker drops ice cubes into ice
storage bucket. During ice production, ice maker arm
raises and lowers. When ice storage bucket is full, ice
maker arm turns ice maker off. Discard first 3 harvests
of ice after initially connecting refrigerator to household
water supply and after extended periods of non-use.
• Stop ice production by lifting ice maker arm. A definite
click is heard when proper position is reached. Ice
maker arm will remain in that position until pushed
down.
CAUTION !
To avoid damage to ice maker, observe the following:
• Do not force ice maker arm down or up.
• Do not place or store anything on ice maker or in ice
storage bucket.