Kleenmaid IC56 - Manual (Page 2)

2
Contents Safety Instructions
WARNING !
To avoid electrical shock which can cause severe
personal injury or death, unplug power cord or open
household circuit breaker to refrigerator before
installing kit. After installing kit, reconnect power.
CAUTION !
To avoid property damage, observe the following:
• Confirm water pressure to water valve is at least 9 kg
(20 pounds) per square inch.
• Start nuts by hand to avoid cross threading. Finish
tightening nuts using a wrench. Do not overtighten.
• Check carefully for water leaks prior to returning
refrigerator to normal location and 24 hours after
connection.
Tools Required
• 9.65 mm ( 3 /
8
") electric drill (ground fault protected)
• 9.65 mm ( 3 /
8
") drill bit
• 6.35 mm ( 1 /
4
") hex nut driver
• 12.7 mm ( 1 /
2
") open-end wrenches (2)
• Adjustable wrench
• Flat blade screwdriver
• Slip joint pliers
• Utility knife
• Masking tape
• Bucket
• Towel
• Tight fitting gloves
Materials Required
Important
• Before connecting ice maker, contact a plumber to
connect copper tubing to household plumbing in
compliance with local codes and ordinances.
• Amana is not responsible for property damage due to
improper installation or water connection.
6 mm ( 1 /
4
") flexible copper tubing*.
*Length of copper tubing must reach from water supply
connection plus an additional 2.5 m (8') for service loop
behind refrigerator. Tubing should be soft instead of rigid
and ends should be free of burrs.
Introduction ................................................................. 2
Safety Instructions ...................................................... 2
Tools Required ............................................................ 2
Important ..................................................................... 2
Parts ........................................................................... 3
Procedure ................................................................... 4
Operating Instructions ................................................. 7
Before Calling For Service ........................................... 7
Warranty ..................................................................... 8
Introduction
!
Recognize this symbol as
a safety precaution.
CAUTION !
To avoid personal injury or property damage, observe
all safety instructions.
Read entire manual before installing kit. All necessary
tools and materials must be available prior to installation.
Verify all listed parts are included in kit. If parts are
missing, contact source from whom kit was purchased.
• Mechanical experience is required to install kit.
• Depending on installer’s knowledge and skill,
installation can take from 3 to 6 hours.
• If unable to solve a problem during installation, contact
an authorized Amana technician. Locate a authorized
technician by calling the source from whom you
purchased the kit.