Koga GENERAL INSTRUCTION - Manual (Page 10)

B
A
B
A
A
B
A
B
Wheels
The wheels have quick release
fittings that enable you to fit and
remove wheels quickly. Make
sure when dismounting the rear
wheel that the chain is on the
middle sprocket wheel on the
front and on the smallest wheel
on the rear. Also see page 8 for
dismounting the brakes.
Quick releases come in two
models:
- Conventional quick release
- Clix quick release
Conventional quick release
• Opening the quick release:
1. Flip the quick release lever
(1A) fully open.
2. Loosen the adjustment nut
(1B).
3. Remove the wheel
• Closing the quick release:
1. Fit the wheel.
2. Turn the adjustment nut
clockwise to the desired
clamping stress (2B).
3. Flip the quick release lever
fully closed (2A).
4. Check that the quick release
lever cannot be turned.
Closing the quick
release lever requires
so much force that you
should need to use the
palm of your hand.
If you don’t need that much force
to close it, turn the adjustment
nut (2B) half a turn clockwise.
If the force required to close it is
excessive, turn the adjustment
nut (2B) half a turn anti-clockwise.
The levers of the quick
releases are never
located on the side of
the chain.
Clix quick release
A Clix quick release is used for a
number of models.
Clix quick releases are
adjusted by the Koga
dealer and do not need
further adjustment.
• Opening the Clix quick release:
1. Flip the quick release lever
fully open (3A)..
2. Pull the ring (3B) towards the
lever.
3. Remove the wheel.
• Closing the Clix quick release:
1. Fit the wheel.
2. Flip the quick release lever
fully closed (3A).
Q-Guard quick release
A Q-Guard quick release is used
for a number for the back wheel
of a number of models.
The handle of this quick release
also functions as a protective
bracket for the rear derailleur.
Open Q-Guard quick release:
1. Flip the quick release lever
(4A) fully open.
2. Remove the wheel.
Q-Guard snelspanner sluiten:
1. Fit the wheel.
10
1 2 3 4