La Crosse Technology WT-5442 - Manual (Page 13)

12
will be in
°C.
G. TIME ALARM
The Projection Alarm has two separate alarms for time, “ALM1” and
“ALM2”. The alarms have a different sound; ALM1 increases in volume
after 25 seconds, and again after 50 seconds. ALM2 is a constant
volume. The total duration is 96 seconds for each alarm.
1. SETTING THE ALARM
a. Press and hold “ALM1” OR “ALM2” for two seconds until the
alarm time is flashing.
b. Press and release“ALM1/HOUR” to advance the hour, and
“ALM2/MIN” to advance the minute. The time will display “PM” if
set to PM, and nothing if set to AM.
c. The projection alarm will revert to normal operation when no
buttons are pressed for 15 seconds. The alarm is now set and
activated.
2. ACTIVATING/DEACTIVATING THE ALARM
a. After entering the alarm-setting mode, the alarm is activated
(either ALM1 or ALM2).
b. To toggle between activating
and deactivating the alarm,
press and release either the
ALM1 or ALM2 briefly. “(((1)))”
or “(((2)))” will be displayed to
the right of the time display
when the alarm is activated
.
c. When the snooze bar is
pressed, the display will scroll
through the Alarm 1 and 2 times in the middle left.
3. TURNING ALARM OFF (WHILE SOUNDING)
a. While either alarm is sounding, press the SNOOZE bar to
disable the alarm for the set duration (Section II. D.). If the
duration is set to “0”, the alarm will be disabled for 24 hours.
b. After the SNOOZE bar is pressed, the lower left will display the
time remaining on the snooze. The SNOOZE bar may be
pressed at any time to restart the snooze duration.
c. To disable the alarm for 24 hours, press any button on the front
of you projection alarm.
H. CHANGING DISPLAY MODE (DAY, SECONDS, AND
TEMPERATURE)
Alarm 2 activated