LEI Electronics TXDOCK - Manual (Page 16)

16
Docking Station with Video User’s Manual
C. Connecting the Docking Station to Computer
1. Assemble the docking station by sliding the main body onto
the base plate to make it self-standing.
2. Plug the power cord of the power adaptor into the DC IN
jack on the back of the docking station and then connect the
power adapter to a working electrical outlet.
The Power indicator on the front panel glows when the
docking station is powered on.
3. Plug the square end of the USB cable into the USB upstream
connector at the back of the docking station.
4. Plug the other end of the USB cable into an available USB 2.0
port on your computer.
Upon the USB connection, your computer will automatically
complete the remaining installation, including installing Windows
built-in drivers for the USB hub.
A pop-up message will appear in the notification area indicating
the installation status. Wait for the final message indicating the
driver software installation is successful. Then the docking station
is ready for use.
D. Connecting Devices to the Docking Station
Now the installation is complete. You can connect the
peripherals/monitor to appropriate ports on the docking station
as required. If required, you can connect and disconnect the
peripherals/monitor any time without disconnecting the docking
station from the USB port on your computer.
Connecting Ethernet network device
1. Connect an Ethernet cable to the Ethernet port on the
docking station.