Leprecon APC Architectural Preset Control - Manual (Page 14)

14
8. Installing panels and faceplates
APC panels consist of three parts:
· Faceplate - 1/8" aluminum snap-on cover, painted and screened.
· Mounting plate - Sub panel that screws to the mounting box.
· Board stack - button and processor boards that are pre-assembled to the mounting
plate.
To install the panels:
1. Separate the faceplate from the mounting plate. A small screwdriver can be used
to separate the panels. Remove the cover carefully to avoid bending the LED
indicators.
2. Attach the mounting plate and board stack to the electrical box using the screws
provided. Make sure all configuration jumpers are set before screwing down the
panel.
3. Do NOT attach the faceplate for the Master panel until programming is complete.
Faceplates can be installed on the slave panels, no further access is needed to
these boards. Simply align the faceplate with the mounting plate, and gently press
into position.