Leprecon APC Architectural Preset Control - Manual (Page 16)

16
To Record Presets:
1. Make sure the face plate is removed from the Master panel.
2. Turn on the DMX controller. The Record LED behind the front panel will light.
3. Using a small tool, gently press the Record switch. The red Record LED will
begin to blink.
4. Set the correct scene using the DMX controller. Once set, press the preset
button that you wish to record.
5. The Record LED will remain stop flashing, but remain on.
6. Repeat the process for each preset.
To set Preset Fade times:
1. Turn off the DMX controller. The Record LED behind the front panel will turn
off.
2. Press a Preset button to select a preset, the adjacent LED will light.
3. Using a small tool, push the Time switch. at the bottom of the panel. The
yellow Time will turn on.
4. After three seconds, the yellow LED will blink once per second. Each blink
indicates 1 second of fade time.
5. To set and store the fade time, press the Preset button again. The time
between the first yellow LED blink and the button press will be captured as the
fade time.
6. If the preset button is not pressed within 15 seconds, Time entry terminates,
the yellow LED turns off, and the fade time for the preset is unchanged.
To set Preset OFF fade time:
Program the 'off' button fade time as described above. This sets the 'fade to
black' time for all presets when the Off button is pressed.