Leprecon LP-X48 Quick Start - Manual (Page 5)

Pro Lighting Equipment
Tips & Tricks
Clear the programmer with Clear + Enter x 2
Clear Manual channels with Clear + ‘Channel’ button
Clear a Playback with Clear + Select above the corresponding submaster in ‘Record’ Mode
Enter key on keypad duplicates the Yes key
When programming your show be sure to place the board in Run mode before turning the power off. This
will save the show information to memory.
There are two modes of operation for the submaster section, Retain & Release.
Release Mode-. When you bring the playback to zero it resets the cuelist back to one.
Retain Mode-When you bring the playback to zero the cuelist retains the last active step and the playback
then becomes a cuelist master. To reset the playback you can hold down the Clear Button and press the
Select Button above the desired playback.
You can get to the modes be going into Set Up>Defaults & Misc.>Retain or Release