Canon A3000 IS - Manual (Page 107)

107
Trimming
You can cut out a portion of a recorded image and save it as a new image
file.
1
Choose [Trimming].
● Press the n button, choose the 1 tab
and [Trimming], then press the m button.
2
Choose an image.
● Press the qr buttons to choose the image
and press the m button.
3
Adjust the trimming area.
X A frame will appear around the portion of the
image to be trimmed.
X The original image will display in the upper
left and the trimmed image will display in the
lower right.
● If you press the zoom button to the left or
right, you can change the frame size.
● If you press the opqr buttons, you can
move the frame’s position.
● If you press the l button, you can
change the frame orientation.
● In an image with detected faces, gray
frames appear around the faces located in
the upper left image. The frames can be
used for trimming. You can switch between
frames by pressing the
0 button.
● Press the m button.
4
Save as a new image and display.
● Follow Steps 4 – 5 on p. 106.
Trimming Area
Trimming Area Display
Recorded pixels
after trimming
• Images with a recording pixel setting of or , or images resized
as cannot be edited.
• The width and height ratio of an image that can be changed is fixed at
4:3 (for a vertical image 3:4).
• The number of recorded pixels in a trimmed image will be smaller than
before trimming.
CO
PY