Louroe Electronics IF-PX - Manual (Page 6)

Page 6 of 8
LOUROE ELECTRONICS® 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458
website: www.louroe.com e-mail: [email protected]
(818)
INSTALLATION AND OPERATING INSTRUCTIONS
FIG. 5
INTERCONNECTION DIAGRAM BETWEEN A PoE SWITCH, IF-PX, NON-PoE ENCODER
AND AOP-SP SPEAKER/MICROPHONE UNIT FOR ADDING TWO-WAY AUDIO
(WHEN USING LOUROE MICROPHONE FOR ONE-WAY LISTEN, JUST CONNECT ONLY
THE AUDIO OUTPUT OF THE IF-PX TO THE AUDIO INPUT OF CAMERA OR ENCODER)
PoE (802.3af) SWITCH
AUDIO OUT
AUDIO IN
20AWG 2 COND CABLE
POWER CONNECTIONS:
+12Vdc connects to +12VDC of Camera/Encoder
GND connects to negative or Ground of Camera/Encoder
12VDC OUTPUT
(OBSERVE POLARITY)
DC OUT
GND +12VDC
AUDIO OUT
AUDIO IN
3 COND SHIELDED 20GA WITH 22GA DRAIN WIRE
( FOR ONE-WAY LISTEN MICROPHONE ONLY, USE
2 COND SHIELDED 22GA WITH 24GA DRAIN WIRE)
DATA ONLY OUT
POWER+DATA IN
AUDIO
DA
TA
OUT
LAN
DC IN
IN
OUT
VIDEO IN
REAR OF IF-PX
NON PoE ENCODER
OR
CAMERA
FRONT OF IF-PX
ANALOG CAMERA
AOP-SP
12VDC INPUT
if-px inst 12/12
3.5MM STEREO PATCH CABLES