Marantz PM5005 - Manual (Page 22)

Connecting devices with remote control connectors
Performing operations by RC on this
unit without visual contact
You can connect an external IR receiver to the REMOTE CONTROL
connectors to perform operations on this unit with the supplied remote
control unit without visual contact. This might be necessary if the unit is
hidden in a cupboard or corner, so you can’t directly point with the remote
control unit to the device.
To do this, disable the remote control signal receiving function “Setting the
remote signal receiving function” (v p. 31).
.
RC OUT
Infrared
retransmitter
Infrared
sensor
NOTE
When a remote control receiver unit is not connected, be sure to enable the remote
control signal receiving function. Operations cannot be performed with the remote
control if this function is disabled.
Remotely connecting Marantz audio
devices
You can transmit remote control signals simply by connecting a Marantz
audio device to the REMOTE CONTROL IN/OUT connectors using the
remote connection cable provided with the device.
Set the remote control switch located on the rear panel of the connected
audio component to “EXTERNAL” to use this feature.
.
Contents Connections Playback Settings Tips Appendix
22 Front panel Rear panel
Remote control
unit
Index