Marantz PM5005 - Manual (Page 33)

Setting remote control codes for the
remote control
o To set the remote control codes to AMP2
1
Hold down REMOTE MODE CD and the number 2
button for more than 5 seconds.
o To set the remote control codes to AMP3
1
Hold down REMOTE MODE CD and the number 3
button for more than 5 seconds.
To return the remote control code to the default setting, hold down REMOTE MODE
CD and the number 1 button for more than 5 seconds.
NOTE
The remote control codes returns to the default settings when the batteries are
removed. Set the remote control codes again after replacing the batteries.
Setting remote control codes for this
unit
1
Point the remote control for which the remote control
code was set at this unit, and press REMOTE MODE CD
and ENTER.
The input indicators on the unit flash as shown below according to
the set remote control code.
Remote control codes Input indicator
AMP 1 PHONO indicator flashes three times
AMP 2 TUNER indicator flashes three times
AMP 3 CD indicator flashes three times
Contents Connections Playback Settings Tips Appendix
33 Front panel Rear panel
Remote control
unit
Index