Marantz NA7004 - Manual (Page 8)

5
ENGLISH
When connecting the optical digital output connector
with an optical transmission cable (sold separately)
Match the shapes then insert fi rmly.
Digital audio input
If a device equipped with CD transport or digital audio output is
connected to this unit, this unit can be used as a D/A converter.
(“Using as a D/A converter” (vpage 19))
M-XPort DIGITAL OUT DIGITAL IN
COAXIAL OPTICAL OPTICAL COAXIAL USB
FLASHER RS232C IN
OUT
IN
REMOTE CONTROL
NETWORK
$0"9*"-
065
015*$"-
065
Signal fl ow
Signal
fl ow
Optical digital
connection cable
(Sold separately) Coaxial digital
connection cable
(Sold separately)
CD Transport /
digital device
NOTE
• Linear PCM signals with a sampling frequency of 32kHz, 44.1kHz,
48kHz, 64kHz, 88.2kHz, 96kHz, 176.4kHz, or 192kHz can be input
into this device.
• Do not input signals other than linear PCM signals, such as Dolby
digital, DTS, AAC etc. into this device. Doing so may cause noise,
which may cause damage to the speakers.
PC connection
By connecting a computer to the USB port on the rear panel of this
unit using a commercially available USB connecting cable, this unit can
be used as a D/A converter. (“Using as a D/A converter” (vpage 19)
Cables used for connections
Audio cable (sold separately)
USB cable
M-XPort ANALOG OUT
R L
DIGITAL OUT DIGITAL IN
COAXIAL OPTICAL OPTICAL COAXIAL USB
N
Signal fl ow
Signal fl ow
USB cable
(Sold separately)
Computer installed with a
media player
USB port
Plug that fi ts the shape of the
connection device connector
Type B
Type A
Digital connection
1.NA7004U_ENG_2nd_100831_校了.indd 5 1.NA7004U_ENG_2nd_100831_校了.indd 5 2010/08/31 20:31:21 2010/08/31 20:31:21