Maytag FAV6800AWQ - Manual (Page 7)

6
O
PERATING
I
NSTRUCTIONS
When setting the cycle and pressing Start/Pause, the display will show the
estimated minutes remaining in the cycle.The estimated time remaining may
fluctuate to better indicate the wash time left in the cycle.
Locked – Lights whenever the lid of the washer is locked.The lid can be
unlocked by pressing the Start/Pause pad to pause the washer.
Pad Indicator Lights – The indicator lights next to the pads will
illuminate when the pad is selected.
Cycle Status Lights – The Cycle Status lights will illuminate to indicate
where the washer is in the selected cycle.
The amount of water used will vary with each load. Since the Maytag ® Neptune ® Top-Load washer is designed for
high-efficiency, you will notice much less water in the tub than a conventional washer.This is normal.The Maytag ® Neptune ®
Top-Load washer uses an adaptive fill system to automatically provide the appropriate amount of water for efficient
cleaning performance and conservation of water and energy. Fill time will vary depending on water pressure.
W
ATER
U
SE
E
STIMATED
T
IME
D
ISPLAY
I
NDICATOR
L
IGHTS
Step 7
• Add detergent and additives to the dispensers (See pages 7-8).
• Close the lid.
• Press the Start/Pause pad.
NOTES:
• When the cycle is complete, the Locked light will go out.The lid will
open easily. Do not attempt to open the washer when the Locked light
is illuminated.To add a forgotten item, see page 3.
• When the washer is started after a pause, there will be a pause of
up to 20 seconds before continuing the cycle.
• Pressing Off cancels the cycle and stops the washer.
• Some cycles are designed to tumble then pause.This is normal.
S
TART
Y
OUR
M
AYTAG
® N
EPTUNE
® T
OP
-L
OAD
W
ASHER