Maytag MAL2000AXW - Manual (Page 4)

3. Reinstall the inlet hoses to the "HOT" and
"COLD" water inlets on the back of the
washer. Turn on the faucets and check hose
connections for leaks. Retighten connections
if necessary.
4. Place the drain hose into the drain standpipe.
5. Plug in the power supply cord for the washer.
Placing The Dryer On The Riser:
1. Tilt the dryer forward and with an assistant, lift
the product carefully and set the unit on the
riser. Figure 6 & 7
2. Make sure the front legs are positioned into
the square rings on the front of the riser.
Figure 8
Figure 6
Figure 7
Figure 8
3. Follow the Installation Instructions that came
with your dryer to finish installing the unit. (i.e.
electrical hookup, vents and etc.)
Note:
For gas dryers the installation must
conform with local codes, or in the ab-
sence of local codes, with the National
Fuel Gas Code ANSI/Z223.1, latest revi-
sion (for the United States), or with the
CAN/CGA-B149 installation codes (for
Canada).
4
Riser
Front
Square
Ring
Figure 5
2. Make sure the front legs are positioned into
the square rings on the front of the riser.
Figure 5
Square
Ring
Riser
Front