Maytag MLI7000AAW - Manual (Page 6)

5
PREPARING TO IRON
1 Preparation
1. Remove the case.
2. Pull the electrical cord out only to the
length required. Insert the plug all the
way into an electrical outlet.
120 V AC
Red tape
• Do not over extend the cord farther
than the section marked by this red
tape.
2 Filling with Water
It is not necessary to pour water into the
water tank if not using the steam or water
spray features.
1. Press down the steam button to set the
iron to the “Dry” position.
2. Remove the tank and fill it with water, up
to the mark indicating “FULL”.
While pressing down
the release button,
remove the tank.
Fill with tap water
• Regions that have extremely hard
water should use a mixture of 50% tap
water and 50% distilled water.
• Do not use water treated by household
soft water systems, as it contains
minerals that are harmful to the iron.
• Do not fill the iron with water in excess
of the mark indicating “FULL”. If too
much water has been poured in,
steam will be discharged continuously
whenever the iron is placed on the
cradle.
3. Close the inlet / outlet spout lid, then
reinstall the tank onto the iron.
Push water tank all the way in until it
clicks.
Up to the mark
indicating FULL
Click!