Maytag WED9051YW Dimension Guide - Manual

Electric Dryer
PRODUCT MODEL NUMBERS
W10443041B
05/2012
WED9050X, WED9051Y, WED9150W, WED9151X,
WED9151Y, WED9250W, WED9270X, WED9371Y
NOTE: Most installations require a minimum
5" (102 mm) clearance behind the dryer for
the exhaust vent with elbow. See “Venting
Requirements”.
Side view:
DRYER DIMENSIONS
Front view:
27"
(686 mm)
1"
(25 mm)
35 3 /
8 "
(899 mm)
3 1 /
2 "
(89 mm)
29"
(736 mm)
Left or
right side
exhaust
6 7 /
8 "
(174 mm)
1 5 /
8 "
(41 mm)
47 1 / 8 "
(1197 mm)
48 1 / 8 "
(1238 mm)
Door open view:
Back view:
Closet Installation (stacked washer and dryer): Closet installation (dryer only):
6 1 /
4 "
(159 mm)
28 1 /
8 "
(715 mm)
3 1 /
2 "
(89 mm)
14"
(358 mm)
Electric
24 in. 2
(155 cm 2 )
48 in. 2
(310 cm 2 )
1"
(25 mm)
1"
(25 mm)
4"
(102 mm)
3"
(76 mm) 34" recommended
(864 mm)
18" min.
(457 mm)
3"
(76 mm)
Custom under counter installation (dryer only):
1"
(25 mm)
1"
(25 mm)
39" min.
(990 mm)
Spacing for recessed area or closet
installation
All dimensions show recommended spacing
allowed, with tested spacing of 0" (0 mm)
clearance on sides and rear.
■ Additional spacing should be considered
for ease of installation and servicing.
■ Additional clearances might be required
for wall, door, and floor moldings.
■ Additional spacing should be considered
on all sides of the dryer to reduce noise
transfer.
■ For closet installation, with a door,
minimum ventilation openings in the top
and bottom of the door are required.
Louvered doors with equivalent
ventilitation openings are acceptable.
■ Companion appliance spacing should
also be considered.
■ No other fuel-burning appliance may be
installed in the same
closet as the dryer.
NOTE: Some models not recommended for
undercounter installation.
1"
(25 mm) 1"
(25 mm)
5 1 /
2 "
(140 mm)
24 in. 2
(155 cm 2 )
48 in. 2
(310 cm 2 )
3"
(76 mm)
3"
(76 mm)
6"
(152 mm)
71"
(1803 mm)
1"
(25 mm)
1"
(25 mm)
4"
(102 mm)
7"
(178 mm)
18"
(460 mm)
Cabinet installation (dryer only):
W10443041B v1-D-WH.indd 1 5/7/12 2:02 PM