Maytag MDB6000AWA Installation - Manual (Page 4)

Leveling legs align the dishwasher vertically and horizontally. A combination of these
two adjustments are necessary to properly position the dishwasher and insure proper fit
of door and latch. Dishwasher must be LEVEL, solid, and square.
LEVEL DISHWASHER LEVEL DISHWASHER
POSITIONING THE DISHWASHER (continued) POSITIONING THE DISHWASHER (continued)
8
SECURING THE DISHWASHER SECURING THE DISHWASHER
Make pilot holes in the underside of counter and drive wood screws, provided in the
accessor y package, through holes in the dishwasher mounting bracket. If part of
the bracket extends beyond the cabinet front, they may be trimmed with wire
cutters, provided sufficient material is lef t to support dishwasher mounting.
It may be necessar y to provide an additional
anchoring source for mounting screws. Wood
strips across the top of dishwasher opening can be
used for solid surface or granite type counters to secure the dishwasher.
Note: Dishwasher must be secured properly to
countertop to avoid tipping when the door is open and
to prevent the tub from twisting.
Leveling Leg
3/16 Hex Head
Door Spring
Adjustment Screw
Tip: Check to be sure there is no interference with water line
and wiring. Verify that power is turned off at source.
Tip: When installing dishwasher near a corner, allow enough room for the door to open
without interferring with any cabinets, drawers, or hardware.
Tip: Disregard the squareness of cabinets, cabinet trim may be used to correct situation later.
Tip: Refer to countertop manufacturer for complete
details on securing dishwasher to countertop.
9
DRAIN HOSE ATTACHMENT DRAIN HOSE ATTACHMENT
If draining into the disposer, check to make sure disposal plug has been removed.
If not, remove as shown.
With dishwasher in permanent position, clamp drain hose to a properly sized
drain line.