12) manual operation and speed change – MBM Corporation AEROCUT G2 User Manual
Page 39
Advertising
38
(12) Manual operation and Speed Change
① Press MANUAL SPEED.
② Use it when operating manually.
③ There are eight feeding speed levels. The currently selected speed level is inverted to
black. Thick paper should not be fed at higher speeds. Please slow the speed down if
sheet stops with noise associated.
Operation
Screen
Manual Operation
Screen
The feeder will
rotate.
The feeder will rotate in
reverse
The guillotine will
operate once.
The creaser stops at
the top dead point.
Move to Adjust Screen
☞
4-(4) If the cut measurement
does not match the input value
The creaser stops at
the bottom dead
Advertising