Measurement Computing ZonicBook Rev.3.0 - Manual (Page 16)

Getting Started, pg. 12 11-01-01 ZonicBook
11. After the Hardware Wizard indicates that it found
the driver file, Click <Next>.
If the driver was installed correctly, a final dialog box will appear, stating that Windows
has finished installing the driver for DSP.
12. Click <Finish>.
This completes the driver installation for Windows 2000. Your computer is now ready to run
ZonicBook software and communicate with the ZonicBook module. After installation is
completed, you can verify that the device has been installed correctly. The verification steps
follow.
Verifying the DSP-Card has been Correctly Installed, for Windows 2000 Users
1. Click on the start menu and click on Control panel
Windows 2000 Users