Measurement Computing ZonicBook Rev.3.0 User Manual

Page 20

Advertising
background image

Getting Started, pg. 16

11-01-01

ZonicBook

12. Click <Next>.

The Hardware Wizard is now ready to install the DSP-card driver
(see following figure).

13. Click <Next>.

14. After the device driver has been installed, click <Finish> (following figure).

This completes the driver installation for Windows Me. Your computer is now ready to run
ZonicBook software and communicate with the ZonicBook module.

Reference Note:
You can use the Windows Control Panel to verify that the DSP-card has been installed
correctly. See,

Verifying the DSP-Card has been Correctly Installed

, on page 19.

Windows Me Users

Advertising
See also other documents in the category Measurement Computing Hardware: