Measurement Computing ZonicBook 618E rev.3.4 - Manual (Page 101)

Appendix A – Using the Daq Configuration Applet A
The Daq Configuration applet, designed for 32-bit Windows NT/2000/XP systems, is located in the
Windows Control Panel. It allows you to add or remove a device and change configuration settings. The
included test utility provides feedback on the validity of current configuration settings, as well as
performance summaries.
To open the Daq Configuration Applet, navigate from the Windows’ Desktop as follows:
Start Menu
⇒ Settings ⇒ Control Panel; then, from the Control Panel, double-click the
Daq Configuration icon.
Device Inventory Dialog Box
After double-clicking on the Daq Configuration icon in the Windows Control Panel, the Device Inventory
dialog box will open. The box displays all currently configured devices. Displayed devices show their
name and an associated device icon, which identifies the device type.
Note: If no devices are configured, no devices will appear in the Device Inventory field.
Daq Configuration - Device Inventory Dialog Box
The four buttons across the bottom of the dialog box are used as follows:
•
•
•
•
Properties: Current configuration settings for a device can be changed by first bringing up the
corresponding Properties dialog box. Open the Properties dialog box by double-clicking on the device
icon or selecting the device and then clicking on the <Properties> button.
Add Device: The <Add Device> button is used to add a device configuration whenever a new device
is added to the system. Failure to perform this step will prevent applications from properly accessing
the device. Clicking on the <Add Device> button will open the Select Device Type dialog box.
Remove: The <Remove> button is used to remove a device from the configuration. A device may be
removed if it is no longer installed, or if the device configuration no longer applies.
Note: If a device is removed, applications may no longer access the device. However, the device
can be re-configured at any time using the Add Device function described above.
Close: The <Close> button may be used at any time to exit the Daq Configuration applet.
Appendix A 987396 Using the Daq Configuration Applet with ZonicBook A-1