Desa CGEFP33PR - Manual (Page 22)

108117
For more information, visit www.desatech.com For more information, visit www.desatech.com
22
INSTALLATION
Installing Logs (VTGF33NR/VTGF33PR) (Cont.)
Installing Logs (CGEFP33PR/CGEFP33NR)
INSTALLATION
Continued
Figure 43 - Installing
Rear Log (#3) Figure 44 - Installing
Crossover Log (#4)
WARNING: Failure to position the parts in accor-
dance with these diagrams or failure to use only parts
specifically approved with this heater may result in
property damage or personal injury.
CAUTION: Do not remove the warning and in-
struction labels attached to the heater base assem-
bly. These markings contain important warranty in-
formation.
CAUTION: After installation and periodically there-
after, check to ensure that no flame comes in contact
with any log. With the heater set to HIGH, check to see
if flames contact any log. If so, reposition logs ac-
cording to the log installation instructions in this
manual. Flames contacting logs will create soot.
INSTALLING LOGS (CGEFP33PR/CGEFP33NR)
Each log is marked with a number. These numbers will help you
identify the log when installing. It is very important to install these
logs exactly as instructed. Do not modify logs. Only use logs
supplied with heater.
1. Locate pegs on the bottom of back log (#1). Slide these pegs into
the holes in the grate base behind the burner (see Figure 45).
2. Place the base of the middle log (#2) in the U-shaped slots of
the grate base in front of the back log. The cutout on the right
of the middle log should fit over the burner (see Figure 46).
Make sure the front of the middle log is resting on the tabs of
the grate base and the cutout area is centered over the burner
“U” bend.
Figure 45 - Installing Back
Log (#1) Figure 46 - Installing Middle
Log (#2)
Figure 47 - Installing Front
Log (#3) Figure 48 - Installing
Crossover Log (#4)
Front Log (#3)
Post
Recess
Post
Crossover
Log (#4)
Hole
Peg
Cutout
Rear
Log (#3)
Peg
Grate
Prong
Groove
in Back
of Log
Groove
in Back
of Log
Grate
Prong
3. Locate the recesses on the back of the front log (#3). Fit these
recesses between the posts of the grate base (see Figure 47).
4. Locate the notches in the bottom of the crossover log (#4). Place
the crossover log on top of the middle log and front log. Make
sure the notches of the crossover log lines up with rectangular
knobs on top of the middle and front logs (see Figure 48).
Hole in
Grate
Base
Back
Log
(#1)
Burner
Burner
Tab
Middle
Log
(#2)
Cutout
U-Shaped Slot
“U” Bend
Crossover
Log (#4)
Rectangular
Knobs