Microcom 48-466 - Manual (Page 56)

Printer Commands Chapter 5
48-466 Operators Manual 50
When the printer is put in auto-print mode, it is not necessary to send a ^D25 to
inform the printer that text is coming or send a ^D35 to tell the printer to print a label.
The printer will accept all incoming data as text strings (except control codes) and
will print a label as soon as the number of strings equals the amount specified by the
^D64 command. At this point, the printer will print a label and continue to accept data.
This mode is useful for interfacing to a device that transmits raw data, such as a
scale or meter.
This is an example of the D63, 64 and 65 Commands...
^A0^D645
^D575
11,832,640,,20,365
1,47,463,10,1,25
2,416,439,20,1,3,,45
3,416,412,25,1,3,,45
4,416,385,25,1,3,,45
5,47,350,10,1,25
6,307,503,30,1,35
7,60,207,29,1,55
7,416,277,20,16,2,,4,2,50,25
8,60,149,29,1,55
9,60,090,29,1,55
10,60,031,29,1,55
^D565
^D25
SHIP FROM:5
MICROCOM CORPORATION5
8333-A GREEN MEADOWS DR., N.5
WESTERVILLE, OH 430815
SHIP TO:5
Order No: XXX5
777777777777777777777777777777777777775
888888888888888888888888888888888888885
999999999999999999999999999999999999995
AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA5
^A3^D635
^A5^D645
^A6^D615
;clear any old settings
;load new format mode
;header
;field info
;field info
;field info
;field info
;field info
;field info
;field info
;field info
;field info
;field info
;field info
;select RAM format
;begin text entry mode
;data line 01 (protected)
;data line 02 (protected)
;data line 03 (protected)
;data line 04 (protected)
;data line 05 (protected)
;data line 06
;data line 07
;data line 08
;data line 09
;data line 10
;enable auto print and clear text
;tell printer to print after 6 (CR)
;tell printer to start new data entry
at data line 6 instead of 1