MicroE Mercury II 6000V - Manual (Page 42)

Page 20
PurePrecision ™ Tape Scale Installation
By Applicator Tool
B6.2.7
At the marked location, place the edge of the tape
scale against the mounting surface reference edge
and press firmly on the end of the tape scale.
Confirm that the following is in contact with the
mounting surface reference edge.
• The guide edge on the bottom of the
applicator tool when reference edge is
0.76mm (0.030 inch) thick.
• The guide surface (rear side) of the
applicator tool when the reference edge
is minimum 9.53 mm (0.375 inch) thick.
Make sure that the end of the tape scale does not
stick to the mounting surface until it is in position
tight against the reference edge.
Section B - PurePrecision ™ Tape Scale Installation