MicroE Mercury II 6000V - Manual (Page 43)

Page 21
PurePrecision ™ Tape Scale Installation
By Applicator Tool
B6.2.8
While pressing down evenly on the tool’s
rollers and against the mounting surface
reference edge, move the tool along the
reference edge at a slow and constant speed
toward the opposite end of travel. Work from
left to right. The adhesive liner is automatically
removed while the tape scale is affixed to the
mounting surface.
Make sure the pressure on the tool is evenly
distributed. Note the finger orientation for
holding the applicator tool.
Once the tape scale has been installed,
discard the adhesive liner.
Place the Applicator Tool on top of the tape
scale and roll it along the length of the scale
while pressing down to assure proper
adhesion. Performing this function more than
once is not necessary but will not have any
adverse effect.
NOTE:
Avoid rolling the Applicator Tool on the
scale if the blue protective film has
been removed.
Section B - PurePrecision ™ Tape Scale Installation
Thumb placed at the
center on the side face
and other fingers follow
along as shown to evenly
distribute pressure