Microsens MS655060-562 - Manual (Page 20)

16
3. To hang the unit on the DIN-Rail track or wall, please refer to the
Mounting Installation section.
4. Power on the Unit. How to wire the power; please refer to the Wiring the
Power Inputs section. The power LED on the unit will light up. Please
refer to the LED Indicators section for meaning of LED lights.
5. Prepare the twisted-pair, straight through Category 5 cable for Ethernet
connection.
6. Insert one side of Category 5 cables into the Ethernet port (RJ-45 port)
and another side of category 5 cables to the network devices’ Ethernet
port (RJ-45 port), ex: switch, PC, or Server. The UTP port (RJ-45) LED on
the unit will light up when the cable connected with the network device.
Please refer to the LED Indicators section for LED light meaning.
7. Connect one end of the fiber cable to the SC single-mode connector on
this converter and the other end of the fiber cable to the SC single-mode
connector on the other 100 Base-FX device.
Note Be sure the connected network devices support MDI/MDI-X. If it
does not support, then use the crossover category 5 cable.
8. When all connections are all set and LED lights all show in normal, the
installation is complete.