Microsens MS400229 - Manual (Page 5)

10/100/100 TX to Gigabit Fiber Media Converter Page 5/7
MICROSENS GmbH & Co. KG · Kueferstraße 16 · 59067 Hamm / Germany · Tel. +49 (0) 23 81/94 52-0 · FAX -100 · www.microsens.com
DIP-switch
The DIP-switch is used to configure operation mode for LLF (Link Lost Forwarding)
and operation mode for UTP/Fiber port. The default value of Dipswitch is OFF.
S/W No Status Description
1
ON LLF Enable
OFF LLF Disable
2
ON Pure converter mode
OFF Switch converter mode
3
ON reserved
OFF reserved
Link Lost Forwarding): When LLF is enable, allow UTP link failures to be reported to
the fiber side and also allow Fiber link failure to be reported to the UTP side. Therefore,
A link loss forward feature is provided in both UTP and Fiber side.
[Note] Please don’t change the DIP-switch setting when UTP or fiber port is
transmitting or receiving data. It may cause some data error.
Rear Panel
The rear panel contains a power socket. This power socket accepts DC9V voltage and
minimum 0.7A supplied current.
DC IN