Microsens MS400934 - Manual (Page 7)

5
Installation
To install the Power over Ethernet Injector, please follow the steps below:
1. Connect one end of the RJ-45 cable to the Switch/HUB and connect
the other end to the Data in port on the Power over Ethernet Injector.
2. Connect the RJ-45 cable between the Data out port of the injector and
the PoE Splitter, PD (Such as Router, Access Point
…etc.) or PoE Hub.
3. Plug in the power cord of the Power over Ethernet Injector to the wall
power plug.
4. Before starting, make sure all connections are correct:
 The Power over Ethernet Injector connects to the Splitter, POE
Hub or PD via Data Out port.
 The Power over Ethernet Injector connects to the switch via Data
In port.
 The AC In connector is to get the power supply to Power over
Ethernet Injector from wall power plug.