Monster FlatScreen SuperThin Flat Mount - Up to 27” Screens - Manual (Page 8)

10 11
Installing the Wall Plate
continued
Masonry Mounting
Masonry mounting requires specialized knowledge, skills
and tools. Monster highly recommends that you seek the
help of a professional installer when mounting to masonry.
DO NOT drill holes in masonry mortar joints.
With the help of a friend, position the mounting plate 1)
in the desired location.
,%6%,
#(%#+
2) Suspend a straight edge, such as a ruler,
across the top of the mounting plate. Place the
provided level on the straight edge and confirm that
the wall plate is plumb straight. Hold the plate firmly
in place.
Mark the centers of the top and bottom center 3)
mounting holes with a pencil. Be careful not to mark
a mortar joint. With your electrical drill and 1/2"
masonry bit, pre-drill a 3" deep hole at each mark.
Install the supplied plastic anchors in each hole. 4)
Tap into hole until fully seated.
Attach the wall plate to the wall using the lag bolts 5)
and round washers as shown on the opposite page.
DO NOT over tighten bolts. This can damage
the wall plate or the surface of your wall.
3/16" Hole
Flatscreen
Wall Plate
Lag Bolts and Washers
Masonry
Wall
Masonry
Wall
Concrete
Anchors