Operating fireplace – Desa EFS10TNA User Manual
Page 27
![background image](/manuals/78139/27/background.png)
www.desatech.com
112462-01G
27
TO TURN OFF GAS
TO APPLIANCE
Shutting Off Fireplace
1. Turn control knob clockwise
to the
OFF position.
2. If Using Optional Hand-Held Remote:
Set remote switch to the OFF position to
prevent draining battery.
Shutting Off Burner Only (pilot stays lit)
You may shut off the burner and keep the pilot
lit by doing one of the following:
1. Turn control knob clockwise
to the
PILOT position.
2. If Using Optional Hand-Held Remote: Use
remote control manual OFF button.
WARNING: Make sure remote
sensor selector switch is in the OFF
position when you are away from
home for long periods of time.
MANUAL LIGHTING
PROCEDURE
1. Follow steps 1 through 5 under Lighting
Instructions, page 26.
2. Depress control knob and light pilot with
match.
3. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob. Now follow step 8 under
Lighting Instructions, page 26.
OPTIONAL HAND-HELD
REMOTE OPERATION
Note:
All remote control accessories must be
purchased separately (see Accessories, page 40).
Follow instructions included with the remote
control.
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions on page 26.
opERaTiNG FiREplaCE
Continued
After lighting, let pilot flame burn for about one
minute. Turn control knob to ON position. Slide
the remote selector switch to the REMOTE
position (see Figure 42).
Note:
The burner may light if hand-held re-
mote was on when the remote selector switch
was last turned off. You can now turn the
burner on and off with the hand-held remote
control unit.
IMPORTANT:
Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
Figure 43 - On/Off Hand-Held Remote
Control Unit
Figure 42 - Setting the Selector Switch
and Control Knob for Hand-Held Remote
Operation
ON/OFF SERIES (MODEL HRC100
AND HRC101)
Hold the control button on the hand-held remote
until burner turns on. Hold the control button
again until burner turns off (see Figure 43).
TO LOCK
press both buttons on hand-held
remote control until light stops flashing. Hand-
held remote control is now locked. If the fire is
on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
TO UNLOCK
press both buttons together
on hand-held remote control until the light
stops flashing. The hand-held remote is now
unlocked.
Control
Knob
Selector Switch in
REMOTE Position
(Optional Hand-Held
Remote Control)
Electronic
Ignitor
Control
Button
Indicator
Light