Nevion EDFA-B-C 17dBm - Manual (Page 4)

EDFA-B-C 17dBm Rev. B
nevion.com | 4
1
Product overview
The Flashlink EDFA-B-C 17dBm is an erbium doped fiber amplifier with a special control
circuit making it better for SDI signals than normal EDFAs. It is a +17dBm booster that is
typically used at the beginning or in the middle of a link. At the receiving end of a link, a low
power / low noise preamp would typically be needed instead.
The EDFA is unidirectional by nature, but can amplify up to 40 DWDM channels on a single
fiber, at 100GHz spacing. Ideal gain flatness is achieved with input power close to the
nominal input power.
Various safety measures are implemented, like automatic shutdown if rear lid is opened to
access the fiber connectors, or manual shutdown by the use of GPI, GYDA, RS422 or
turning the safety key to the “off” position. There is also a reduced output power mode that
can be entered with the use of GPI, GYDA or RS422 control.
EDFA can also be directly controlled over RS232, bypassing the Flashlink features. The
key, lid, GPI and GYDA/RS422 still operate the shutdown and reduced output power
modes, even when using direct RS232 control.
EDFA status is monitored by use of LEDs, GPIO and RS422/GYDA.
Figure 1: EDFA block diagram