Nevion 3GHD-EO-2-SFP - Manual (Page 8)

3GHD-EO-2-SFP Rev. B
nevion.com | 8
Table 1: DIP settings.
Switch # Label Function, DIP=OFF Function, DIP=ON Comment
1 EQ1 Bypass Automatic cable
Equalizer Automatic cable
Equalizer on
electrical input 1
2 EQ2 Bypass Automatic cable
Equalizer Automatic cable
Equalizer on
electrical input 2
3 Not used
4 Latch Non-latching switch.
Will automatically
return to main when
input signal is ”good” Latching switch. Must
be reset to return from
standby to main “Sticky” switching
”good” is depending
on switch criteria in
change-over mode.
5 Main Input 1 is main Input 2 is main Select’s main input to
changeover
6 Not used
7 Not used
8 OVR GYDA control.
Configuration with
GYDA Override GYDA
control. Configuration
with DIP switch Select configuration
from GYDA
9 RCL1 Reclocker 1 bypass Reclocker 1 enabled Sets reclocker mode
for output 1
10 CHO1 Change over
disabled Change over enabled Enables change over
for output 1
11 SEL1 Input 1 to output 1 Input 2 to output 2 This setting are
overridden if DIP 10
(CHO1) is enabled
12 Not used
13 RCL2 Reclocker 2 bypass Reclocker 2 enabled Sets reclocker mode
for output 2
14 CHO2 Change over
disabled Change over enabled Enables change over
for output 2
15 SEL2 Input 1 to output 2 Input 2 to output 2 This setting are
overridden if DIP 14
(CHO2) is enabled
16 Not used
All DIP switches are off when pointing towards the release handle.