Nevion 3GHD-OE - Manual (Page 17)

3GHD-OE / 3GHD-OE-2 Rev. F
nevion.com | 17
7 RS422 commands
This card uses the FLP 4.0 protocol to be configured and monitored. See separate
documents for definition of this protocol.
7.1 FLP4.0 block commands
Common FLP4.0 block for both single and dual converter is listed below.
7.1.1 PIN 0
Optical input 1. Long haul version supports optical level.
<identifier> ::= 'pin'
<status> ::= ['cd'|'ncd'] [<rssi>'dBm']
7.1.2 TEMP 0
Board temperature.
<identifier> ::= 'temp'
<status> ::= ['alarm'] [<temperature>'C'] ['ulim' <temperature>]
['llim' <temperature>]
<block command> ::= <upper limit>|<lower limit>
<upper limit> ::= 'ulim' <temperature>
<lower limit> ::= 'llim' <temperature>
7.1.3 PWR 0
<identifier> ::= 'pwr'
<status> ::= [<nominal voltage>'Vnom'] [<voltage>]
7.1.4 PWR 1
<identifier> ::= 'pwr'
<status> ::= [<nominal voltage>'Vnom'] [<voltage>]
7.1.5 PWR 2
<identifier> ::= 'pwr'
<status> ::= [<nominal voltage>'Vnom'] [<voltage>]
7.1.6 PWR 3
Only for long haul version.
<identifier> ::= 'pwr'
<status> ::= [<nominal voltage>'Vnom'] [<voltage>]