NewHank Roommate - Manual (Page 2)

QUALITY AV PRODUCTS
NEWHANK - www.newhank.com - ROOMMATE Instruction Manual Page 2
INTRODUCTION
BASIC PRINCIPLES
ADJUSTMENT
Welcome to the NEWHANK ROOMMATE professional 19" mixers series user manual.
Roommate is a 4 Zone stereo matrix mixer,
. Connect and control up to 3 Microphones and 11Stereo line Sources, like CD Play-
ers, Radio’s, Satellite- and Cable- receivers etc.
As a bonus the additional Dual USB connections enable a 2-channel Stereo Audio feed from a MAC or PC. This
manual describes how ROOMMATE can work for you. By incorporating the latest surface mount technology and
a "Green" switch mode power supply ; we have created a reliable highend/ low noise audio mixer that will serve
you well for many years to come.
meaning that any of the 6 input channels can be freely routed to any
of the 4 stereo zone outputs
1. Study the rear panel connections on page 4.
2. Make sure all devices are turned off and all faders, zone and gain rotary's are closed.
3. Connect all your stereo input sources as described on page 4.
4. Connect the stereo master and zone -outputs to power amplifier(s), powered speakers and so on.
5. Plug all devices into AC power.
6. Always switch your system on in the following sequence:
1. Audio input sources (like DVD- CD Players, Tuners etc).
2. Mixer.
3. Amplifiers, Powered speakers etc.
Always switch your system off in reverse sequence:
1. Amplifiers, Powered speakers etc.
2. Mixer.
3. Audio input sources (like DVD- CD Players, Tuners etc).
1. Select the Input source (10) and channel while your connected audio device is in playback mode.
2. Engage the Master/PFL (18).
3. While still keeping the channel, master and zone rotary's in closed position, now engage the “PFL”(11) of the
corresponding channel.
4. Adjust the gain rotary (6) with a screwdriver till you see the input level in the blue area of the VU meter bar rea-
ding on average between - 7 and - 0 dB.
5. Adjust the channel fader to 75% open.
6. Finally adjust the master and/or zone rotary with a screwdriver to the find the desired room level.
7. Repeat these steps for all line input channels.