Olson Technology OTRR-3000 - Manual (Page 10)

REV. X4 Page 10
Mount modules to enclosure using #8 screws and split lock washers. It is suggested that the modules be mounted with
the RF and Optical connectors mounted down to prevent moisture from entering. For a watertight seal, pot the optical
connectors with RTV. If the enclosure provides enough water protection you can skip this step.
There are no user adjustments on modules. To optimize Tx RF input, external attenuators maybe required.
* Connect the optical fiber to both the transmitter and receiver. Insure the optical loss to the receiver is less
than the maximum allowed
* Verify the proper RF level out of the LNB and connect the LNB output to the RF input of the transmitter
* Connect the RF out of the receiver to the distribution amplifier or TV set top receiver
* Apply power to both modules, the system should now be operational as there are no user adjust
ments required on the modules
TYPICAL Applications
MDU (Multiple Dwelling Unit)
Typical Multiple Dwelling Unit