OnLine Power Mini Power Wave - Manual (Page 29)

6005-100 Rev A
20
11. Technical Specification
Specifications for 120V/277V
Capacity (W) 200W 300W 490W
Voltage Single Phase 120Vac or 277V
Voltage Range 120Vac ±10% or 277V
Frequency 50Hz or 60Hz +/- 4Hz
Input
Power Factor > 95%
Voltage (on battery) Single Phase 120Vac or 277V
Voltage Range 120Vac ±2% or 277V
Frequency (on battery) 50 / 60 Hz +/-0.5%
Transfer Time 0 ms
Overload Recovery Auto transfer to UPS
High Efficiency mode (AC to AC) > 95 %
Output
UPS Design Technology On-Line / Fully digitized microprocessor controlled
Surge Protection 120V (IEEE C62.41) / 230V (IEEEC61000-4-5 level 3)
Overload Protection 125% for 1 minutes and 150% for 10 seconds Protection and Filtering
Short Circuit Protection Circuit breaker
Visual Display
(LED model)
UPS on(green), line-mode(green),
battery mode(yellow), bypass(yellow), fault(red)
Visual Display
(LCD model)
Input / output voltage, input / output frequency,
on-line mode, back up mode, battery capacity, load level
Audible Alarm Beep every 5 sec
UPS Fault Continuous beeping sound and LCD display
System/Display/ Warning
Communication RS-232 Serial Port and USB
Battery 90 min. 2X35 A/H 2X50 A/H 2X50 A/H
Dimensions Inches (width x Height x depth) 24 x 17 x 9.5
Note: Due to continuous improvement specifications are subject to change without prior notice