OpenEye CM-511 - Manual (Page 46)

46
SCHEDULE
The schedule function enables users to program a preset point or function (Tour/Auto Scan/Pattern)
automatically to perform in a specific period of time.
Switch
Select <ON> to enable or <OFF> to disable the schedule function.
Point
Users are allowed to arrange 32 sets of schedule points, i.e. each set of schedule points can be assigned
one kind of schedule mode.
Hour / Minute
This is used to set up the time to execute each schedule point.
Mode
This is used to set up the schedule function of the selected schedule point; the options are listed as
follows.
NONE - No action will be executed for the schedule if the item is selected.
PRESET - Users can select the PRESET mode as an action carried out in a schedule point.
TOUR - Users can select the TOUR mode as an action carried out in a schedule point.
AUTOSCAN - Users can select the AUTOSCAN mode as an action carried out in a schedule point.
PATTERN - Users can select the PATTERN mode as an action carried out in a schedule point.
IR FUNC. (IR Function) - If select the IR function mode, the AUTO IR FUNCTION will be activated for a
schedule point.
Schedule Reset
Select <YES> to reset the entire schedule.
Exit
Exit the SCHEDULE menu and go back to the MAIN PAGE 3.