OpenEye CM-410 - Manual (Page 41)

28561AA 31
GROUP SETUP
GROUP SETUP
------------------------
GROUP NO. 1
UNDEFINED
CLEAR GROUP CANCEL
<EDIT GROUP>
BACK
EXIT
Group Number [1~8]
Selects Group number to edit.
If a selected Group number is not defined, "UNDEFINED"
will be displayed under selected Group number.
Clear Group [CANCEL/OK]
Deletes data in current Group
Edit Group Starts editing Group.
EDIT GROUP
EDIT GROUP 1
------------------------
NO ACTION ### DWELL OPT
------------------------
1 NONE
2 NONE
3 NONE
4 NONE
5 NONE
------------------------
SAVE
CANCEL [NEAR:EDIT]
1. Press Near key in “NO” list to start Group setup.
EDIT GROUP 1
------------------------
NO ACTION ### DWELL OPT
------------------------
1 NONE
2 NONE
3 NONE
4 NONE
5 NONE
------------------------
SAVE [NEAR:EDIT ACT]
CANCEL [FAR :EDIT END]
2. Note that MAX. 20 Functions are allowed in a Group. Move cursor up/down and
press Near key to set up.
EDIT GROUP 1
------------------------
NO ACTION ### DWELL OPT
------------------------
1 NONE
2 NONE
3 NONE
4 NONE
5 NONE
------------------------
SAVE [ :MOVE CURSOR]
CANCEL [ :CHANGE VAL.]
3. Set up Action, Dwell time and Option. Note that selected item is displayed in
reverse. Move cursor Left/Right to select items and move cursor Up/Down to
change each value.
Action ### [NONE/PRESET/SWING/PATTERN]
DWELL [0 second ~ 4 minutes]
Sets Dwell Time between functions
OPT Option. Displays the preset speed when preset is set in
Action. Displays the number of repeats when Pattern or
Swing is selected in Action