Orion System OE361-13 CommLink 5 - Manual (Page 7)

Form: Orion-OE415-02-IPModuleKit-01B.doc
Page 1 of 1
Description
The OE415-02 IP Module Kit (when installed and
configured in the CommLink IV or CommLink 5
communication interface) provides TCP/IP Internet
and/or intranet connection for Ethernet networked
computer systems allowing them to communicate
with your control system. The OE415-02 IP Module
Kit consists of the IP Module and a 10 ft. long
CAT5 Ethernet crossover cable.
The IP Module plugs into a mating 40 pin (2 x 20)
connector located on the CommLink’s circuit
board. Installation is easily accomplished by re-
moving the CommLink’s case cover screws, re-
moving the case cover to access the circuit board,
and then plugging the IP Module into its mating
socket connector. Correct alignment is made easy
because of the (4) slot alignment tabs located
around the perimeter of the processor base. It is
not possible to incorrectly align the IP Module to
the socket connector because of this feature.
The TCP/IP connection provided by the IP Module
installed in the CommLink is a TCP connection on
a single port number and is static in nature. Fire-
wall and proxy servers can easily be configured to
allow traffic to and from the CommLink when the IP
Module is installed. The nature of the data is raw in
form and comprised of packets native to Prism II
software. The IP Module will respond to ICMP traf-
fic (PING) for verification of proper configuration.
Prism II software is required in order to read and
send data to the IP Module and through the
CommLink to the control system. The IP Module
connects to the host Ethernet system by means of
the supplied 10 ft. long CAT 5 Ethernet crossover
cable which plugs into the 10/100 Base-T, RJ-45
jack on the back of the CommLink IV and into a Ethernet router or Ethernet modem on your building’s LAN. Set-
up of the CommLink with the IP Module requires a knowledgeable IT person familiar with configuring network
adapters and TCP/IP systems. Prism II software must be installed on the local LAN computer(s) and/or remote
Internet computers that will be used to program and monitor the control system.
OE415-02 IP Module Kit
Technical Data OE415-02 IP Module Kit
Operating Temperature 10
F to 140F Media Access Control CSMA/CD with ACK
Operating Humidity 90% RH Non-Condensing Network Connection 10/100 Base-T Ethernet
RJ-45 MDI Socket
Protocols Supported ARP, UDP, TCP, Telnet,
ICMP, SNMP, DHCP, BOOTP,
Auto IP, HTTP, SMTP, TFTP
Flow Control XON/XOFF (Software), CTS/RTS
(Hardware), None
Network Interface IEEE 802.3 RJ45 Ethernet
10BASE-T Or 100BASE-TX
(Auto-sensing)
Management Internal Web Server, SNMP (Read
Only), Serial Login, Telnet Login,
Device Installer Software
3 Year Warranty WattMaster reserves the right to change specifications without notice
1.28”
1.3
4
”
CAT5 Ethernet Cable
IP Module