Orion System E-BUS Digital Room v.1 - Manual (Page 7)

Operator Interface
E-BUS DIGITAL ROOM SENSOR
7
Setpoint Adjust Screen
Touching <> or <> will dis-
play the Setpoint Adjust Screen.
You can adjust the cooling and
heating setpoints from this screen
based on the VCB-X or VCC-X
Controller slide offset setpoint.
For example, if the connected
controller’s Max Slide Offset
Setpoint is set for fi ve, you can
adjust the setpoint up fi ve degrees
and down fi ve degrees.
NOTE: If the VCB-X or VCC-X Controller’s slide offset setpoint
is set to Zero, this screen will not appear when you touch
<
> or <>.
Figure 9: Operation Mode Screens
Cooling Mode
with Snowfl ake Icon
Heating Mode
with Flame Icon
Vent Mode
with Fan in Motion Icon
Figure 8: Setpoint Adjust
Screen
Unoccupied Mode
with Moon Icon
Operation Modes
Refer to Figure 9 for operation mode screen examples. The different
icons shown are a Snowfl ake for cooling mode, a Flame for heating
mode, a Fan in motion for vent mode, and a Moon for unoccupied
mode. When the unit is in unoccupied mode, the screen’s background
will turn dark.
Sensor Operation