QuickLabel S-100 - Manual

THREE-YEAR LIMITED WARRANTY
Your QuickLabel Systems S-100 Label Slitter (“the Unit”) is guaranteed
to the original end user purchaser to be free from defects in workman-
ship and materials under normal use for a period of three (3) years from
original date of purchase. This Warranty begins when you purchase the
Unit and continues for three (3) years unless you sell or rent the Unit, in
which case the Warranty terminates.
In the event warranty service is required, please contact QuickLabel
Systems for a Return Material Authorization (RMA) number and the
location to which the Unit should be shipped. The Unit must be packed
securely for shipment to avoid damage. Proof of original purchase must
accompany the Unit. The customer assumes all costs incurred in
transporting the Unit to an authorized service center. Upon examina-
tion, if the Unit is found defective, it will be repaired or replaced without
charge during the Warranty period.
QuickLabel Systems disclaims any implied warranty, including the
warranty of merchantability and the warranty of fitness for any particular
purpose, and assume no responsibility for any special, incidental, or
consequential damages.
This Warranty does not cover damage resulting from accident, misuse,
abuse, improper installation or operation, lack of reasonable care,
unauthorized modification, the affixing of any attachment not provided
by QuickLabel Systems, or loss of parts. This Warranty is voided in the
event any unauthorized person opens, alters, or attempts repair of the
Unit.
The included DC Power Supply Module Warranty Period is one (1) year.
QuickLabel Systems
A Product Group of Astro-Med, Inc.
World Headquarters:
600 East Greenwich Avenue
West Warwick, RI 02893
Telephone:
401-828-4000
Toll Free: 877-757-7978
Fax: 401-822-2430
www.QuickLabel.com
E-mail: [email protected]
QLS-S100S200 Operations Manual.p65
Rev. March 2005
S-100 Label Slitter (6.5”)
S-200 Label Slitter (10”)
· Introduction
· Specifications
· Setup and Use
· Maintenance
· Warranty
The S-100 Label Slitter shown
with 2-blades and the optional
PC-1 Preset Counter installed.
Introduction
The QuickLabel Systems Model S-100 & S-200 Heavy-Duty Label Slitters are
designed for use with the QuickLabel Systems RW-2 or RW-P8 Label Rewinder. For
production applications, or with more than 2-cutting Blades, off-line use with an
Unwinder and Rewinder is recommended.
During slitting, the Special High Speed Slitting Blades are stabilized with QuickLabel
Systems’ proprietary system, giving a clean cut at all speeds. The blades are fitted
into click-stop adjustable holders and can be used over most of their length,
maximizing their useful life. Replacement blades are available from QuickLabel
Systems.
The QuickLabel Systems S-100 & S-200 Label Slitters greatly increase your printer
efficiency when producing small labels, and allow use of the full width of your
printhead, giving optimum performance and better ribbon usage.
Specifications
Speed: Same as printer speed for in-line use.
Up to 30 ips (800-mm/sec) in off-line use.
Width: S-100 : Up to 6.5 inches (165-mm).
S-200 : Up to 10-inches (254-mm).
Blade Capacity: 2-blades included. Maximum for in-line use.
Maximum 4-blades recommended for off-line use.
Blades are field installable.
Extra Blade Holder & Blade (P/N 26541-101).
Power: Slitters require no power.
Optional: 5-digit Preset Counter sends “HALT” command to
QuickLabel Systems RW-2 or RW-P8 Label
Rewinder when the slitting job is finished. Requires