Datalogic Scanning POWERSCAN PD7100 - Manual (Page 14)

12 PowerScan ® PD7100 Corded
Keyboard Standard Default Settings (Keyboard AT) —
Coun-
try Mode = U.S., Caps Lock= OFF, Numlock Key =Unchanged, Send
Control Characters = Disabled, Wedge Quiet Interval = 100ms, No
Wedge Intercode Delay.
Resetting the Standard Product Defaults
If programming settings for your reader are in an unknown condition,
factory settings can be restored by scanning the “Standard Product
Default Settings” barcode below. A listing of factory default settings is
available in the PRG. Settings can vary, depending upon the interface
type.
Symbologies
Symbologies are factory enabled or disabled in the reader as follows:
Enabled Symbologies
• UPC-A, UPC-E, EAN 13, EAN 8 — without add-ons, Check
Character Transmission enabled, no Expansion, Minimum Reads
= 1 (except In-Store Minumum Reads = 2), System Number
Transmission = enabled, 2D Components = disabled, EAN 8
Guard Insertion/Substitution Options = disabled (except EAN 8
Guard Substitution), Stitching = disabled.
• Code 39 — Check Character Calculation/Transmission enabled,
Start/Stop Character disabled, Full ASCII disabled, Quiet Zones =
auto, Minimum Reads = 1, Decoding Level and Aggressiveness =
3, Variable Length Control, Length One = 2, Length Two = 50,
Interdigit Ratio = 4, Character Correlation = Disabled, Stitching is
enabled.
• Code 128 — No Expansion, Check Character Transmission
enabled, SubCode Change not transmitted, Quiet Zones = Auto,
Minimum Reads = 1, Decoding Levels and Aggressiveness = 3,
Standard Product Default Settings