Datalogic Scanning POWERSCAN PD7100 - Manual (Page 3)

Statement of Agency Compliance
Quick Reference Guide 1
Statement of Agency Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the following two con-
ditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
FCC Class B Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital device
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that inter-
ference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio or television technician for help.
Canadian Notice
This equipment does not exceed the Class B limits for radio noise emissions as described in the
Radio Interference Regulations of the Canadian Department of Communications.
Le present appareil numerique n’emet pas de bruits radioelectriques depassant les limites applicables
aux appareils numeriques de la classe B prescrites dans le Reglement sur le brouillage radioelectrique
edicte par le ministere des Communications du Canada.
Power Supply
Models require either a Listed class II or class III with a Limited Power Source (LPS).
For the safety certification to be valid, class III input power sources must be IEC/EN60950-1 (EN
60335-series, EN 60065 or relevant) approved. CEC IV Efficiency Regulations Compliance.
Input: 90-264 VAC Output: 5 VDC
Max. Current: 0.5 AMax. Power: 12.5 W Max.
Use only the authorized power supplies supplied by your Datalogic reseller. The use of any other
power supplies can damage the reader and void your warranty.
Solids and Water Protection
The reader has an IEC rating of IP65.
NOTE
For USB Power Off Terminal applications, attach to USB 1.0, 1.1
or 2.0 host device only.