Randall Amplifiers NB KING100 - Manual (Page 2)

QUICK START GUIDE
START UP
After you have plugged in and connected the AC power cord securely from the
wall to the amplifier, connect only a high quality speaker cable from the Speaker
output jack to the input jack of your extension cabinet. Make sure that you plug
into the correct Speaker output jack which matches the impedence of your cabinet.
For example: If you have a 16 ohm cabinet then make sure you are plugged into
the jack labeled 16 ohms. Now that the amplifier has been hooked up
correctly, simply plug your guitar into the front panel Input jack using a high
quality instrument cable and flip the Power switch to ON.
Once the amplifier is powered up it will default to the the Clean channel. Set all
the Drive, Level & EQ controls to straight up except for the large Master
control which should be set all the way down. Turn the amp from Standby to On
then bring up the Master control slowing until you reach the desired volume level.
This
channel is perfect for all clean tones, but really shines for Funk style as well as
vintage blues tones.