Remotec ZXT-310 V1.2 - Manual (Page 10)

10
IR Code Selection
Selecting an IR Device Code in ZXT‐310
L Important
− Please make sure that the “End point selection control” has
completed (if necessary) before process the following setup.
Step Setup Key
LED Indication
Status on
ZXT‐310
1
Make sure ZXT‐310 switched to
Channel 1 (EP1) • LED flashes
once then
keep on
2
Refer to your primary controller
instructions to process the
configuration setup procedure.
‐ Parameter: 27
‐ Value: 0001 (Refer to IR code list of
ZXT‐310)
‐
3
Press the PROG button on
ZXT‐310 • LED flashes
twice then
keep on
• Entering
device code
successful
Note 1: Red LED flashes 6 times means that the setup process is failed.
Please redo the process again.